Chemicals for soft soldering
Flux Firescoff 30ml
€34.99*
Content:
30.00
The revolutionary all-in-one Firescoff is a nano-particle-based, easy-to-spray, ceramic protective coating. This ensures an extremely consistent flow of solder and at the same time protects the metal against heat-related tarnishing.
In addition to protecting stones and metals, Firescoff retains the original alloy, color and patina of precious metals. Completely water-soluble, Firescoff dispenses with acid-based pickling solutions. This makes your soldering work safer, faster and cheaper. Simply spray Firescoff on the workpiece, solder and rinse with warm water. Firescoff is non-flammable, free of fluoride and chloride.
- Replaces Flussmitel, heat protection and stain
- Protection against heat-induced tarnishing of the metal
- Perfect, non-prone welds
Consistent and predictable solder flux
- Multiple soldering possible by a single application
- supports preparation time by up to 60%
- Original metal paint and patina are preserved
- Free of fluorides - suitable for rubies and sapphires
- Non-toxic, no toxic fumes during soldering
- Easy rinsing with water - no stripping necessary
Application:
Carefully heat the metal to about 120 ° Celsius. Spray Firescoff so that a fine mist completely covers the piece of jewelry. When Firescoff is applied correctly, it immediately forms a white, puddy, dirt film on contact with the metal. Heat the metal again. Apply a little more Firescoff if you still see a reflection of metal or stone. Because Firescoff is also a flux, no additional flux is needed. After soldering, the Firescoff dirt film can simply be rinsed with warm water or removed in the ultrasonic blast.
Content: 30ml
Dangerous goods: no
Shelf life: approx. 2 years
Flux Firescoff, 120ml
€77.99*
Content:
120.00
The revolutionary all-in-one Firescoff forms an easy-to-spray, ceramic protective layer based on nano-particles. This ensures an extremely consistent solder flow and at the same time protects the metal from tarnishing caused by heat.
Firescoff not only protects stones and metal, but also preserves the original alloy, color and patina of precious metals. Completely water-soluble, acid-based pickling solutions can be dispensed with with Firescoff. This makes your soldering work safer, faster and also cheaper. Simply spray Firescoff onto the workpiece, solder and wash off with warm water. Firescoff is non-flammable, fluoride and chloride free.
- Replaces flux, heat protection and stain
- Protection against heat-related tarnishing of the metal
- Perfect, pren-free welds
- Consistent and predictable solder flow
- Multiple soldering possible with a single application
- Eliminates the preparation time by up to 60%
- The original metal color and patina are retained
- Free of fluorides - suitable for rubies and sapphires
- Non-toxic, no toxic fumes when soldering
- Simple rinsing with water - no stripping necessary
Use:
Carefully heat the metal to approx. 120 ° Celsius. Spray on Firescoff so that a fine mist completely covers the piece of jewelery. If Firescoff has been applied correctly, it immediately forms a white, powdery protective film on contact with the metal. Reheat the metal. Apply a little more Firescoff if there is still a reflection of metal or stone visible. Since Firescoff is also a flux, no additional flux is required. After soldering, the Firescoff protective film can simply be rinsed off with warm water or removed quickly using an ultrasound.
Content: 30ml
Dangerous goods: no
Shelf life: approx. 2 years