Product number:
249739
Product information "GRS Index ring holder set"
The GRS ID ring holder redefines holding of rings. By tightening the clamping axle, the clamping sleeve is pressed into the clamping cones on both sides. This creates uniform pressure and spreads the clamping sleeve evenly. This holds the ring securely on the inside. When using the standard cone, the tension can be adjusted so that the ring can rotate easily during engraving. In contrast, the clamping cone locks the clamping sleeve so that the
ring is held in a fixed position. This allows for secure stone setting. The ring holder is a good, affordable choice if you are looking for a simple, functional, and high-quality solution.
Includes: (1) ID ring holder, (2) sets of 10 pieces each of clamping sleeves, (2) standard cones, (2) cones with special toothing, (1) clamping axle, (1) retaining nut, (1) hex nut, and (1) GRS Allen wrench.
Clamping sleeve diameter:
13.5 mm, 14.5 mm, 15.5 mm, 16.5 mm, 17.5 mm,
18.5 mm, 19.5 mm, 20.5 mm, 21.5 mm, 22.5 mm
Pictured in the assembled state with 18.5 mm
clamping sleeve and standard cone.
ring is held in a fixed position. This allows for secure stone setting. The ring holder is a good, affordable choice if you are looking for a simple, functional, and high-quality solution.
Includes: (1) ID ring holder, (2) sets of 10 pieces each of clamping sleeves, (2) standard cones, (2) cones with special toothing, (1) clamping axle, (1) retaining nut, (1) hex nut, and (1) GRS Allen wrench.
Clamping sleeve diameter:
13.5 mm, 14.5 mm, 15.5 mm, 16.5 mm, 17.5 mm,
18.5 mm, 19.5 mm, 20.5 mm, 21.5 mm, 22.5 mm
Pictured in the assembled state with 18.5 mm
clamping sleeve and standard cone.
| Article name: | Index ring holder set |
|---|---|
| Brand: | GRS |
| Catalogue item No.: | 004-735 |
| Clamping range: | 13.5 - 22.5 |
| Gross weight grams: | 230.00 |
Documents
Accessoires (optional)
Outside holder for ID ring holder
€91.99*
This holder offers you more freedom when engraving rings on the outside or on the edge of the ring. This holder can be attached at different angles in a vice. The set screws help to fix the holder in the vice or may be omitted for a additional mobility.This holder is intended for use with an existing ID Ring holder (#004-735). Together with the new ID ring holder replacement kit ((#004-707), available separately, you may even attach a complete ring holder
Replacements
